We use a few cookies

Essential cookies keep the library working. With your permission, we'd also like to use analytics to see what's useful and improve the experience. Read our Privacy Policy or Cookie Policy.

Skip to main content
Home/e-Resources/Mechanical Engineering/Rotary Friction Welding and Dissimilar Metal Joining of Aluminium and Stainless Steel Alloys
PeriodicalsMechanical Engineering

Rotary Friction Welding and Dissimilar Metal Joining of Aluminium and Stainless Steel Alloys

Checking your access to this record.

Abstract & Overview

Friction welding (FW) is cost-effective, efficient, occupational safer and also eco-friendly in the absence of pollution, smoke, fume, and IR radiation during welding than conventional welding technologies. In this paper, the joining of aluminium AA6063 and steel SS304 dissimilar metal is explained with different faying surfaces and their SEM images of weld interface (WI), joint quality, tensile and yield strength, and the axial shortening are evaluated and compared. The joint quality factor of the experiment faying surface modification ‘E3’ was the maximum and about >100% with 236 MPa strength. The axial shortening was also less than 27 mm. The joint with hemispherical faying surface showed ‘U’ shaped WI and the joint with taper faying surface showed ‘V’ shape WI. So, the cross-sectional area of WI can be increased and the strength also increased. FW yields very high strength, low-stress weld with no weld defects such as porosity, voids etc. Here, in most cases, the joint strength is equal to base metal strength and it can avoid fastening to join two metals. FW has a minimal and narrow heat-affected zone (HAZ) of few microns size that differentiates FW from other welding techniques. The grain size of HAZ is directly proportional to the heat input during welding. During fusion welding of dissimilar materials, a lot of intermetallic compounds are formed at the weld interface and that will lead to poor strength of the welding because they have different chemical and mechanical qualities; therefore FW is a good choice for joining dissimilar metal rods as the intermetallic compounds can be reduced by FW.

Cite this record

S Senthil Murugan, P. Sathiya, A. Noorul Haq (2021). Rotary Friction Welding and Dissimilar Metal Joining of Aluminium and Stainless Steel Alloys. Annals of Dunarea de Jos University of Galati Fascicle XII Welding Equipment and Technology, 32, 85–92. https://doi.org/10.35219/awet.2021.11

Copy in another style

Murugan, S. S., Sathiya, P., & Haq, A. N. (2021). Rotary Friction Welding and Dissimilar Metal Joining of Aluminium and Stainless Steel Alloys. Annals of Dunarea de Jos University of Galati Fascicle XII Welding Equipment and Technology, 32, 85–92. https://doi.org/10.35219/awet.2021.11
Author names are used as deposited, so check their order before you submit.

Metadata is harvested from open-access indexes and can be incomplete. Check a citation against the published version before relying on it — see our open access & attribution policy.