Abstract & Overview
The growing demand for sustainable engineering materials has intensified research into agro-waste-based reinforcements for polymer composites. In this study, the compressive strength of a bio-epoxy composite reinforced with powdered Pentaclethra macrophylla pod an abundant agricultural by-product—was analyzed and optimized for brake and structural applications. The pods were cleaned, dried, pulverized, sieved into selected particle sizes, and partially carbonized prior to incorporation into a bio-epoxy matrix. Composite plates were fabricated using a pre-impregnation and hot-press technique, with pod content varied between 10 and 50 wt.% and particle size as a secondary factor. At the same time, other additives were maintained at constant proportions. The compressive strength of the developed composites was measured in accordance with ASTM D6641. Experimental optimization was performed using Response Surface Methodology (RSM) with a Central Composite Design (CCD), which facilitated the evaluation of the interactive effects of the process variables and the prediction of optimum compressive strength. The maximum values recorded were 84.6-106.6 N/mm for maximum compressive strength at the particle size of 150μm and a filler content of 20–30% (w/w), which were close to the predictions obtained using the CCD models. These results are consistent with previously studied systems using other bio-fillers blended in epoxy and with the fact that the mechanical properties of such composites increase up to a critical concentration of filler, beyond which they are reduced due to aggregation of fillers and poor interfacial interactions. Pentaclethra macrophylla pod could be an alternative low-cost and ecofriendly reinforce in for bio-composites applied for producing non-asbestos brake pad and light structural parts