We use a few cookies

Essential cookies keep the library working. With your permission, we'd also like to use analytics to see what's useful and improve the experience. Read our Privacy Policy or Cookie Policy.

Skip to main content
Home/e-Resources/Agriculture/Optimization and production of bioethanol from cashew apple juice using immobilized yeast cells by Saccharomyces cerevisiae.
PeriodicalsAgriculture

Optimization and production of bioethanol from cashew apple juice using immobilized yeast cells by Saccharomyces cerevisiae.

Checking your access to this record.

Abstract & Overview

Ethanol has been known for a long time, being perhaps the oldest product obtained through traditional biotechnology. A study was taken up to evaluate the role of some fermentation parameters like substrate concentration, pH, temperature andinoculum concentration on ethanol production from cashew apple juice using immobilized yeast cells by Saccharomyces cerevisiae. This paper mainly focused on identifying the optimum conditions resulting revealed that the substrate concentration 10 per cent, pH 6.0, temperature 32.5°C and inoculum level of 8 percent (v/v) on 24 hours which gives maximum yield of ethanol 7.62 per cent respectively. This study could establish the effective utilization of cashew apple juice for bioethanol production with optimized fermentation parameters using immobilized yeast cell technology. Key word:Saccharomyces cerevisiae Immobilization cell Cashew apple juice Ethanol Continuous fermentation INTRODUCTION MATERIALS AND METHODS Total demand for ethanol is expected to reach around Substrate and Pretreatment: Waste cashew apples were 3x10 in 2010 [1]. However due to increasing petroleum brought from a factory processing cashew apples to 11 shortage, fermentation production of ethanol from extract the juice. Cashew apples are cut into slices in order renewable resources has received considerable attention to ensure a rapid rate of juice extraction when they are [2]. Nowadays, fermentation technology produces nearly crushed in the juice press. The fruit juice is sterilized in 80% ethanol as clean fuel and for which Saccharomyces stainless steel pans at a temperature of 85°C in order to cerevisiae is considered to be of most important yeast eliminate any wild yeast. This juice, which contains high strain because of its biotechnological application in the levels of tannins, was clarified by adding gelatin to field of fermentation technology [3]. In order to improve remove tannins and suspended solids [9]. Then the its substrate utilization range, several manipulation of the clarified juice was filtered and treated with either sodium strains was carried without any success [4].However or potassium metabisulphite, to destroy or inhibit the immobilized cell technology has been suggested as an growth of undesirable types of micro-organisms such as effective mean for improving ethanol production [5] acetic acid bacteria, wild yeast and moulds. Juice sample Ethanol production by immobilized yeast cells has been was filled in jars (capacity 2.5 liters) and was preserved at extensively investigated during the last few decades. 4°C to prevent any possible degradation or spoilage The most widely used immobilization methods are during storage. This treated juice sample (contains 26.5% based on cell entrapment in gels, such as carrageen and of total reducing sugars) was used throughout the Ca alginate [6, 7]. experimentation Among the different substrates cashew is considered to be an in expensive substrate for ethanol Microorganism and Growth Condition: The laboratory production [8]. However the conditions optimum for mutant strain of yeast was used throughout the ethanol production has not been studied extensively. experiments. The yeast strain was maintained in Hence to present study was undertaken to optimize the MYmedium (in g/L): glucose, 20; yeast extract, 3; conditions suitable for ethanol production using cashew polypeptone, 5; malt extract, 3; agar, 20. In all cases, apple juice as substrate. cultures were maintained at 30 °C for 24 h and then stored Am-Euras. J. Sci. Res., 4 (2): 85-88, 2009 86 at 4 °C. Subculturing was done in every 2 months. The Effect of Operational Parameters: The effect of inoculum composition of the pre-culture medium for yeast was (in g/L): glucose, 15; sucrose, 15; yeast extract, 3; polypeptone, 5; malt extract, 3. The cells were cultivated in this medium in a controlled environment shaker at 28°C for 20 h in order to obtain high cell density. At the end of incubation period, cells were centrifuged aseptically and resuspended in fresh preculture medium to be used as inoculum. The compositions of the fermentation media (in g/L) were: (a) glucose, 70; sucrose, 80; polypeptone, 50; MgSO , 10; KH PO , 0.5; (b) glucose, 100; sucrose, 4 2 3 100; polypeptone, 80; MgSO , 12; KH PO , 0.6. All the 4 2 3 mediums were adjusted to pH 5.5 and autoclaved at 116°C for 20 min before use. Immobilization and Cultivation Procedure: The yeast cells were immobilized in Ca-alginate using an electrostatic drop generation method. The 2 % (by mass) Na-alginate solution was prepared by dissolving 4.8 g of sodium alginate powder into 240 ml of distilled water. Polymer/cell suspension was formed by mixing 240 ml of Na-alginate solution with 60 ml of thick yeast suspension at room temperature. Spherical microbeads were formed by extrusion of Na-alginate/yeast cell suspension through a blunt stainless steel needle using a syringe pump with a 20-ml plastic syringe and an electrostatic droplet generator. The cell suspension was forced out of the tip of the needle at constant flow rate (0.25 ml/min) anddroplets were formed by the action of electrostatic and gravitational forces. Electrostatic potential was formed by connecting the positive electrode of a high voltage DC unit to the gelling bath, which was 2.65 % (by volume per mass) CaCl solution. In this way, the yeast cells were 2 entrapped in a gel matrix of Ca-alginate. The immobilized particles were rather uniform in size with the mean diameter of 0.6 mm. After gelling, the microbeads were placed in double distilled water to remove the unreacted material. Until use, the microbeads with cells were stored in a physiological solution at 4 °C. Fermentation Parameters for Ethanol Production Preparation of Inocula for Fermentation: The freshly prepared yeast cultures of S. cerevisiae on agar slants were inoculated into 100 ml MY broth in 250 ml Erlenmeyer fl asks and incubated at 30±2°C for 24 h on a rotary shaker. A cell count of about 3.6x10 and 2.1x10 cell ml respectively was obtained 8 8 1 after 24 h and the same were used as inoculum for future experiments. size on ethanol fermentation by the process of immobilized cultures of S. cerevisiae was carried out by varying the inoculum concentration of both S. cerevisiae from 2 to 10 % (v/v). Effect of temperature on ethanol fermentation by the process of immobilized mixed cultures of S. cerevisiae was carried out by varying the temperatures to 25, 27.5, 30, 32, 32.5 and 35°C and temperatures were established only at the beginning of the experiment. Effect of incubation period and agitation time on ethanol fermentation was carried out by varying the incubation period and agitation time from 0 to30 h. Continuous Flow Reactor: Continuous flow reactor is provided with an inlet foe substrate intake and an outlet for product output.the height of the reactor is 50 cm and diameter is 5 cm approximately.the top and bottom ends of the reactor were embedded with perforated plates for the ingress of the substrate and for retaining of packing material an air inlet is provided to supply air for growth of organisms. Gas outlet is provided at the top of the reactor to release gas formed during fermentation process. A peristaltic pump is connected to the reactor to maintain the flow rate of the substrate. The column was packed with fibrous material of cashew apple to retain the organism. The substrate with culture was passed to the reactor countercument flow through inlet provided at the bottom of the reactor the product was taken out from outlet provided at top of the reactor up to the specific fermentation time the product was recycled with substrate. Sample was collected for every four hours and analyzed in gas chromatography. Analytical Procedures: Juice sample was analyzed for total sugar and glucose by DNS (Dinitrosalicylic acid) reagent[10] and was confirmed at 540 nm by Biospectrophotometer (Elico). Ethanol was estimated using NUCON 5765 Gas Chromatography (GC) with a flame ionization detector and Poropak Q (3m x 0.32 cm) column using Nitrogen as the carrier gas at the rate of 35 ml/min. The oven temperature was held at 80°C. The injector and detector temperature was maintained at 200°C. RESULTS AND DISCUSSION Effect of Substrate Concentration on Ethanol Yield of Cashew Apple Juice: Effect of substrate concentration was studied by conducting experiment with different substrate concentration values (6,7,8,9,and 10%).

Cite this record

T. Neelakandan, G. Usharani (2009). Optimization and production of bioethanol from cashew apple juice using immobilized yeast cells by Saccharomyces cerevisiae. AMERICAN-EURASIAN JOURNAL OF SUSTAINABLE AGRICULTURE, 4(2), 85–88. https://library.shubhaarti.com/content/f8ffc51e-299a-4e4e-b98b-5dfd5ff9da21

Copy in another style

Neelakandan, T., & Usharani, G. (2009). Optimization and production of bioethanol from cashew apple juice using immobilized yeast cells by Saccharomyces cerevisiae. AMERICAN-EURASIAN JOURNAL OF SUSTAINABLE AGRICULTURE, 4(2), 85–88. https://library.shubhaarti.com/content/f8ffc51e-299a-4e4e-b98b-5dfd5ff9da21
Author names are used as deposited, so check their order before you submit.

Metadata is harvested from open-access indexes and can be incomplete. Check a citation against the published version before relying on it — see our open access & attribution policy.